Printer Setup

Okidata Microline 320 Turbo

Printer Settings

Insert a blank sheet of paper into the printer.
Enter Menu Mode:
Press and hold the Shift and Sel buttons at the same time. The Menu light should come on. If it does not come on turn the printer off, then back on, and repeat this step.
Set the printer's Emulation Mode to "IBM PPR":
Press the Group button (located under LF). The printer should print:
```
General Control       Emulation Mode       xxxxxxxxxx
```
If the Emulation Mode is set to IMB PPR, skip to step 4.
Press Set until it prints:
```
General Control       Emulation Mode       IBM PPR
```
Set the Bottom Margin to "Invalid":
With the Menu light still on, press Group until the printer prints:
```
Top Feed       Line Spacing       xxxxxxxxxx
```
Press Item. The printer should print:
```
Top Feed       Bottom Margin       xxxxxxxxxx
```
If the value for Bottom Margin is "Invalid", skip to step 5.
Press Set. The printer should print:
```
Top Feed       Bottom Margin       Invalid
```
Set the Paper Out Override setting to "Yes":
With the Menu light still on, press Group until the printer prints:
```
Set-Up       Graphics               xxxxxxxxxx
```
Press Item. The printer should print:
```
Set-Up       Paper Out Override     xxxxxxxxxx
```
If the value for Paper Out Override is "Yes", skip to step 6.
Press Set. The printer should print:
```
Set-Up       Paper Out Override     Yes
```
Set the Auto Select setting to "Yes":
With the Menu light still on, press Item until the printer prints:
```
Set-Up       Auto Select     xxxxxxxxxx
```
If the value for Auto Select is "Yes", skip to step 7.
Press Set. The printer should print:
```
Set-Up       Auto Select     Yes
```
Press and hold the Shift and Sel buttons at the same time to turn off Menu Mode.

Install the Okidata 320 turbo driver for Windows

Go to Start -> Printers and faxes
Double click on Add Printer
Follow the instructions on the screen to complete the drive installation
Print a test page to make sure the printer has been installed correctly